Appendix; Troubleshooting; Block Diagram - Ranpak PadPak PPLC2 Betriebsanleitung

PadPak LC
®

5. APPENDIx

EN
5.1

Troubleshooting

Problem
Converter will not power
on.
Converter is turned
"On" but does not
produce paper.
Feed or cut
machine status
End of web status
(*) Contact your Ranpak Distributor Service Technician if the problem has not been solved
5.2

Block diagram

11
Cause
1. On/Off switch is in "Off" position.
2. Power plug is defective.
3. Fuse is defective (melted).
4. Poor / defective connection.
1. Paper is torn on perforation.
2. Converter not reset.
3. Front/rear covers are open.
4. Emergency Stop button is activated.
jam, 1. Paper jam.
1. Converter is out of paper.
Power
supply
Solution
1. Set the switch to the "On" position
2. Check the power plug (*).
3. Check the fuses (*).
4. Check the connections (*)
1. Reload the paper and reset the converter.
2. Press the Reset button to reset the converter.
3. Make sure the front/rear covers are closed.
4. Make sure the Emergency Stop button is not
engaged.
1. Remove paper jam:(*)
◦ Push the
simultaneously
◦ Pull remaining pads out of the converter
chute
◦ Reset the converter
◦ Paper should now feed normally;
1. Reload the paper and reset the converter.
If problem persists, check the angle of the
End of Web sensor or contact your Ranpak
Distributor Service Technician.
USER
INTERFACE
PLC
Commodity
M
Process
Product
PadPak PPLC2 Operator Manual - EN
2 cut/reverse buttons