PadPak
LC
®
EN
Figure 20 – Reset machine to cut
3.5.8 Machine Statistics
Machine Statistics (Figure 21) can be displayed by
selecting the [F1] key next to the F1=Statistics label on
the Home Screen (Figure 1). The Hours the Feed motor
has run, number of pads made and total paper used (in
ft or m) is displayed. Press the [ESC] key to return to the
Home Screen.
3.5.9 Machine Speed Selection
Machine feed speed can be adjusted on the Home Screen
(Figure 1). Press the [+/-] key next to the Speed: label to
select the desired operating feed speed. PLEASE NOTE:
The speed may also be set directly from the Footswitch
Mode screen.
3.6
Turning the Converter Off
After use, the converter can be turned off by setting the
main switch to the "Off" or "0" position.
3.7
Cleaning
Any personnel can clean the exterior of the converter.
Prior to cleaning, remove the power plug from the wall
socket.
The converter can be cleaned with:
•
A damp cloth
•
Vacuum-cleaner.
The converter must not be cleaned with:
•
Detergents
9
Figure 21
•
Excessive amounts of water.
Clean the converter on the inside by removing any large
paper pieces by hand and subsequently cleaning it with a
vacuum-cleaner (first pull the plug from the wall socket; it
is recommended to wear hand protection).
If the converter is cleaned by someone other than the
operator of the converter (e.g. a cleaning department or
external cleaning company), these persons must have
the correct instructions to safely carry out the cleaning
activities
3.8
Maintenance
Before performing maintenance on the converter, the
electrical supply must be turned off by pulling the power
plug from the wall socket.
Pay attention to sharp edges, corners
and knives of the converter due to the
risk of cutting.
Warning!
Do not operate the converter when
the safety
devices
removed.
Warning!
Maintenance of the converter should be performed at least
once a week:
•
Open the front cover of the converter by loosening the
hard knobs and allow the front cover to fully open
•
Remove scraps of paper
•
Wipe with a dry, damp cloth to remove excess paper
dust
•
Close the front cover.
At least once a year, the converter needs to be inspected
by a qualified person.
The following points need to be checked:
•
Various converter adjustments
•
Operation of the safety provisions
•
Legibility of the warning stickers
•
Wear and tear of parts
•
Clean cutting area
•
Quality of the "pad".
3.8.1 Repair / Replacing Parts
Repairs can only be carried out by a qualified service
technician.
•
Only Ranpak supplied parts are permitted for use as
replacement parts.
•
Parts can be ordered by a Ranpak distributor.
•
Deviating from the instructions above can affect the
safety of the converter. The manufacturer cannot
accept liability for such deviations
PadPak PPLC2 Operator Manual - EN
are switched off or