Usage Of The Operator Devices; Operating The Padpak Lc - Ranpak PadPak PPLC2 Betriebsanleitung

PadPak LC
®
3.4

Usage of the Operator Devices

Operation / Function Keys:
1.
2.
3.
4.
5.
6.
7.
8.
9.
PadPak PPCL2 Operator Manual - EN
Tilt/Angle Adjuster
Power Button
- Set the main switch to
"On"
- Rotate the Emergency
Stop button (#8 above)
counterclockwise to
reset the button
Accessory Ports
includes:
- 1 or 2 Foot Switches
- 1 Bin Full
- 1 End of Web
Reset Button
(error
indicated on display screen)
- Emergency Stop button
engaged, safety covers
open, cut jam or feed
jam
- MUST press blinking
Reset button to operate
converter
Paper Loading
(see section 3.3 for paper
loading instruction)
Cut/Reverse Buttons
(press simultaneously for)
- Manual Cut and
Reverse
Mode Selector
1 Foot Switch
2 EDS
3 Preset
4 Automatic
5 Recipe
Emergency Stop Button
Paper Feed Buttons
3.5

Operating the PadPak LC

After completing all required actions as stipulated in section
3.2 "Turning the Converter On" the PadPak material can
be produced, using the following modes:.
It is not permitted to make a Pad shorter
than 25 cm because this increases the
risks of paper jams and additional risk
Warning!
of jamming and cutting!
3.5.1 Changing the Control Panel Language
(Languages available: English, Spanish, French, German,
Dutch, Italian, Czech, Polish, Danish and Swedish)
1. Turn the converter off and then power the converter
back on.
2. Press the F1 key when the control panel prompts you
to select a language.
3. Use the ▲ and ▼ keys to select the appropriate
language.
4. Press the [ESC] key
3.5.2 Foot Switch Mode (Key 1)
1. From the Home Screen (Figure 1), press the [1] key to
go to the Footswitch Mode screen.
Figure 1
2. Once on the Footswitch Mode screen (Figure 2), press
the foot switch to feed paper and release to cut to
desired length. The length (in or cm) of the pad will be
displayed on the screen (Figure 2).
Figure 2
EN
4