KKT KOLBE GS6013ED Benutzerhandbuch Seite 63

Troubleshooting
E3: The expiration period is longer or extended.
• The drain pipe can be located too high or wrong. Read the installati-
on instructions and make sure that the installation is properly done.
• Check that the drain hose is not knotted or kinked.
• Make sure that the drain hose is not longer than the length of the
original hose.
E3: The unit found presence of water in the case of the
dishwasher.
• Check that the drain hose is not knotted or kinked.
• Check if there are congested locations in the drain hose or if maybe
the drain system is clogged to which the washer is connected.
• The drain pipe can be located too high or wrong. Read the installati-
on instructions and make sure that it is properly installed.
• After you correct the error that led to the display of the error codes,
connect the power back to the power supply.
• Switch the dishwasher on with the ON / OFF button and wait 5 se-
conds before you set your own program using the program selection
buttons.
After you have corrected the error that led to the respective error
!
code on the display, reconnect the device to the power supply.
Switch it on again using the ON / OFF button and wait 5 seconds.
If a different error code is shown on the display, do not try to eli-
minate the error yourself but contact customer service.
If repair costs incurred during the warranty period due to im-
!
proper operation of the unit, the customer must pay these costs
themselves.
63