Ribimex Ribiland Bedienungs- Und Wartungsanleitung Seite 16

5.2.2- Pressure parameters
The pump starts operating as soon as it is connected to the electricity supply, when water is still detected
after 10 seconds, the pump will keep operating.
When the pump pressure reaches the Max pressure setting (the internal pump pressure is over 3.5-4.0bar),
or when there is no water coming out from the outlet, the pump stops working automatically.
When the pump pressure is lower than the Min. pressure setting (the internal pump pressure is lower than
1.5 bar), the pump starts operating again.
Warning!
Never operate the pump without water (dry running).
The pump is not designed for continuous operation! (e.g. continuous water circulating operation).
The submersible pump must be immersed before switching on.
Place pump into water, then let it purge the air (air bubbles) then only you can connect it.
Important advice
- Sand and other abrasive substances increase wear and tear and reduce the pump's performance.
Do not use the pump in such environment.
- When you use the pump for watering a garden, so as to ensure regular water flow and to preserve the
life time of the pump, we recommend you to use a watering terminal (e.g. spray nozzle, spray gun ...)
fitted to the hose with a flow rate greater than 10 liters / minute.
Page 16 / 34