Maintenance And Storage - Ribimex Ribiland Bedienungs- Und Wartungsanleitung

VI. MAINTENANCE AND STORAGE
Before any intervention on product, ensure that product is disconnected from its power source.
6.1- Maintenance
- In winter, the pump must be carefully drained or placed in "frost" protected condition.
- Regularly rinse with clear water pump, including the suction line.
- After using the pump in a swimming pool or garden pond/basin, thoroughly rinse it with clean water,
including the suction line.
- Avoid pumping liquid containing abrasive materials such as sand.
- Before restarting, make sure of the good condition of every part of the pump.
- Clean plastic parts with a clean, soft cloth.
- Do not use aggressive cleaning product (solvents, detergents) or abrasive sponges or sharp or pointed
objects.
ATTENTION: This pump is intended for clean water and is equipped with a filter sponge, in the bottom,
to filtrate the particles. It is therefore recommended that the filter sponge be cleaned very often.
6.2- Breakdown
- Never attempt to dismantle the pump.
- If necessary, have it checked and repaired by an authorized centre (consult your dealer).
6.3- Trouble shooting
Incidents
Pump does not start
No flow
Pump does not switch
off
Insufficient flow
Pump switches of
after short operating
period
6.4- Storage
- Clean the pump.
- Pump must be stored in a dry, ventilated location. Always lock up product and keep out of reach of
children.
6.5- Disposal
- Do not dispose the product with household garbage. Do not throw into the environment.
- Dispose of the product in a collection centre for waste of electrical and electronic equipment, or a waste
drop-off centre; or seek advice from your local municipality.
- Disposal of the product, accessories and packaging should be carried out according to local regulations
governing environment protection.
Causes
-Power supply not connected
-Floater does not switch
-Inlet sieve is clogged
-Pressure hose in bent
-Floater cannot sink down
-Inlet sieve is clogged
-Reduced pumping capacity by dirty and
abrasive water
- Dirty water: thermal cut-out stops pump
- Water too hot: thermal cut-out stops
pump
Remedies
-Check power supply
-Raise position of floating switch
-Clean inlet sieve water jet
-Reset hose
- Place pump vertically underwater
-Clean inlet sieve
-Clean pump and replace worn-out parts
-Remove mains plug. Clean pump and shaft
-Make sure that a water temperature of
max.35℃ is not exceed
Page 17 / 34