General Instrument Settings; Selecting The Velocity Curve; Resetting The Factory Settings And Songs - Viscount Chorum S10 Bedienungshandbuch

Chorum 10 Dlx – Chorum S10

6. GENERAL INSTRUMENT SETTINGS

6.1 SELECTING THE VELOCITY CURVE

The keyboard of Chorum 10 is touch sensitive. It is also possible to choose one of the three key velocity
curves available or four fixed values that will influence the response to the sound of orchestral voices and
MIDI notes.
N.B.
Organ registers are not subject to key velocity.
To select the desired velocity curve, follow this procedure:
1.
Holding down the [SET] button press the [REC] button: all LEDs on the panel flash twice.
2.
One of the LEDs of the [TRANSPOSER] button lights up indicating the curve currently selected
in this order (left to right): Soft, Normal, Hard, Fixed at 32, Fixed at 64, Fixed at 96, Fixed at 127.
3.
Select one of the options by repeatedly pressing [TRANSPOSER].
4.
Press the [REC] button to complete and store the operation.

6.2 RESETTING THE FACTORY SETTINGS AND SONGS

The instrument provides various ways of restoring the factory data which are present at the time of
purchase. It is possible to restore:
-
Only the instrument settings (combinations, Split point, Ensemble, intonation, voices volumes,
tremolo, orchestral voices, Local Off, MIDI settings, general settings).
-
Only factory songs.
-
The instrument settings and the factory songs.
To recall a recovery operation:
1.
Holding down the [SET] button press the [REC] button: all LEDs on the panel flash twice.
2.
Holding down the [SET] button,
-
To restore only the settings of the instrument, press and hold the button [2] of the
combinations until all the LEDs on the panel do not flash twice, then turn off and on the
instrument again.
-
To restore only the factory songs, press and hold the [3] button of the combinations
until the LED of the combination LED flashes once.
-
To restore both instrument settings and factory songs, press and hold the button [4]
of the combinations until all the LEDs on the panel do not flash twice, then turn off and
on the instrument again.
3.
Press the [REC] button to return to normal operation.
EN - 15
User Manual