Inhaltsverzeichnis
Werbung
40 40
35 35
89 89
51 51
63 63
85 85
86 86
41 41
88 88
87 87
37 37
46 46
83 83
87 87
42 42
49 49
90 90
38 38
50 50
200
200
66 66
48 48
39 39
04 04
52 52
30 30
03 03
02 02
74 74
44 44
34 34
33 33
43 43
75 75
91 91
45 45
205
205
206
206
84 84
82 82
62 62
36 36
56 56
55 55
45 45
54 54
201
201
12 12
08 08
78 78
61 61
65 65
79 79
77 77
31
The part reference "B135-C ; B135-CA" includes the following:
– Basic tool complete with battery and shoulder strap
– Spare battery
22
– Battery charger
– Plastic carrying case "VAL P9-C"
23
19
17
2. INSTRUCTIONS FOR USE
2.1) Preparation
(Ref. to Figs. 1 and 2)
The tool can be easily carried using either the handle or the shoulder strap (T) attached
to the rings (R and R1).
72
With the tool in the rest position proceed as follows:
53
– Select the appropriate die set for the connector.
– Insert the die (91) into the upper seat of the tool head (39) until it is locked by die/head
72
retaining pin (50). To ease die insertion, keep die/head release pin (49) depressed.
53
– Press the operating button (06) to advance the ram (41) 3-4 mm (0.11 - 0.16 in.) and
insert the die (90) into the seat on the ram until it is locked by die/ram retaining pin (85).
To ease this operation, keep die/ram release pin (88) depressed.
– Insert the conductor in the connector.
13
– Position the connector between the dies and ensure the correct location of the crimp
204
points.
203
67
N
EVER PRESSURISE THE TOOL WITHOUT INSERTING THE DIES
72
CAUSE DAMAGE TO THE HEAD AND THE RAM
53
32
72
53
2.2) Die advancement
57
Press the operating button (06) to ac-
58
tivate the motor-pump and advance the
59
lower die. This fi rst stage rapidly closes
the dies to the connector.
To halt the advancement, release the
60
operating button (06) and the motor
will cut out.
80
68
Make sure the dies are exactly posi-
tioned on the desired crimp point
otherwise re-open dies following
57
instructions as per § 2.5 and reposi-
tion the connector.
2.3) Compression
58
– By keeping operating button (06) pressed, the motor continues to operate: the tool will
59
automatically change over to the high pressure stage and the ram (41) will gradually
move forward until the two dies touch.
60
64
– It is recommended to continue pumping until the maximum pressure valve is activated
and a "click" is heard.
4
70
18
16
70
18
70
18
70
18
,
AS THIS COULD
21
.
11
71
23
20
47
29
47
26
06
69
76
202
201
73
14
05
15
ENGLISH
Werbung
Inhaltsverzeichnis
