Tools; Factory Default - Videotec ULISSE COMPACT HD Bedienungsanleitung

• Other: It allows setting other values: Image
Mirror, Noise Reduction, Wide Dynamic (Visibility
Enhancer), High Resolution, Aperture Control,
Defog, Highlight Correction.
Fig. 50
30

9.2.15 Tools

From menu entry Tools it is possible to re-set the
predefined values for the entire configuration of Pan
& Tilt or only for a number of specific sections.
This section:
• Update the firmware of the device.
Restart the pan & tilt.
Fig. 51

9.2.16 Factory Default

To restore the factory settings relative to the network,
user access and camera configuration follow this
procedure:
• Switch off the unit.
• Open the configuration door (7.2.1 Opening the
configuration door, page 18).
• Set all DIP 3 dip-switches to ON.
• Power the unit. Wait for 2 minutes.
• Switch off the unit.
• Restore the NETWORK protocol in DIP 3.
• Power the unit.
Enter address: 192.168.10.100.
MNVCUCHD_1511_EN