Digital I/O; Wiper; Washer - Videotec ULISSE COMPACT HD Bedienungsanleitung

9.2.10 Digital I/O

In the Digital I/O tab it is possible to configure the
digital channels available in Pan & Tilt. What follows is
a brief description of the configurable parameters for
each digital input.
• Alarm ID: Field used to select the desired digital
input.
• Type: It indicates the default state of the digital
input. It can be set Normally Open or Normally
Closed.
To check correct operation of the alarms, a dot will
appear on the web page. The dot will be green
in normal conditions and red when an alarm is
detected.
Fig. 47
28

9.2.11 Wiper

Do not use the wiper when the outside
temperature is below 0°C or in case of ice.
The integrated wiper does not interfere with the
viewing range of the installed camera.

9.2.12 Washer

The Pan & Tilt wash pump is configured in the Washer
tab where it is possible to associate a preset to the
washing operation, set the duration of washing and
specify the wiper on/off delay.
Fig. 48
MNVCUCHD_1511_EN