Video Analysis Page; Tools Page; Factory Default - Videotec ULISSE COMPACT HD Bedienungsanleitung

Fig. 53 Example of configuration: OSD region clockwise.
Fig. 54 Example of configuration: OSD region anti-clockwise.

9.2.16 Video Analysis Page

The device can be configured to emit motion
detection alarms using ONVIF events.
This page allows you to define the following settings:
• Enable emission of motion detection events.
• Configure the algorithm sensitivity level.
Fig. 55
MNVCUCHD_1801_EN
Start
0°
Stop
Start
0°
Stop

9.2.17 Tools Page

From menu entry Tools it is possible to re-set the
predefined values for the entire configuration of
device or only for a number of specific sections.
This section:
• Update the firmware of the device.
• Restart the device.
Fig. 56

9.2.18 Factory Default

To restore the factory settings relative to the network,
user access and camera configuration follow this
procedure:
• Switch off the unit.
• Open the configuration door (7.6.1 Opening the
configuration door, page 18).
• Set all DIP 3 dip-switches to ON.
• Power the unit. Wait for 2 minutes.
• Switch off the unit.
• Restore the NETWORK protocol in DIP 3.
• Power the unit.
Enter address: 192.168.10.100.
31