7/ Diagnostic Of The Failures; Securities - POOL TECHNOLOGIE Minisalt Handbuch

 Rinse the cell and then reassemble it
 Recalibrate your inversion frequency in the reduction (see §5.3 p.20).
The lifespan of the cell is very closely linked to the respect for the instructions indicated in this user manual (see
§5.1 p.37). We recommended using exclusively cells of origin. The use of compatible cells can entail a reduction in
the production and reduce the life cycle of the device. A deterioration linked to the use of a compatible cell
cancels the contractual warranty by that fact.

7/ DIAGNOSTIC OF THE FAILURES

1
WINTERIZING
When AL flashes, it means that the device has detected a problem.

Securities

Lack of Chlorine production is stopped.
water Check the presence of water flow in the cell.
Lack of Chlorine production is stopped.
salt Check the salt rate in the pool with your usual analysis kit.
Controller Chlorine production is stopped.
problem You have to contact a professional so that he proceeds to the repair of the Controller.
Chlorine production is stopped.
1/ Check visually that the cell is not scaled.
Cell 2/ Check that the connexions to the borders of the cell are not oxidized and well squeezed.
problem 3/ In most of cases, this code shows that your cell is totally used and cannot produce
chlorine.
You have to contact a professional to proceed to the replacing of the chlorination cell.
If an alarm starts in an inappropriate way (defect of the flow sensor for example), it is possible to deactivate it with
the code AL in the CHLORINATION menu (see § 4.2 p.18).
Originally, the alarm AL is deactivated by default. If necessary, this function invites the user to activate
manually this order.
A shock chlorination and a strong correction of the pH by adding acid or soda in skimmers risk activating the
alarm without any reason.
MINISALT – PAPI004086MULTI1- FR/EN/ES/DE – Rev.03.14
Causes / Remedies
24