Pool Equipped With A Pool Cover; Chlorine Production Regulation - POOL TECHNOLOGIE Minisalt Handbuch

TH (°f)
Inversion frequency (hours)
Important: the automatic cleaning of the cell does not have authority to compensate a hardness of very
high water. Beyond a TH of 60°f, first of all, it is imperative to act on the balance of the water to lower its
hardness.
4 POOL EQUIPPED WITH A POOL COVER (depending on model)
 If your pool is equipped with a pool cover, the chlorine production must be reduced when the shutter is
shut.
 The device is equipped with a function that will take care of it automatically.
 Press 3 s on
and then enter in the chlorination menu, « In » flashes.
V
 Activate the pool cover mode (Code Co in the control menu, see § 4.2 p.18) and confirm with
 Select the wished state between ON and OF and confirm using
then the screen display returns to the control panel (display of the production %).
 When the pool cover will be closed, the device will shows :
5

CHLORINE PRODUCTION REGULATION

The chlorine production of the device settles in production percentage, from 0 to 10 (100 %), using
(depending on model ; 0 being the «stand-by» mode).

Check the rate of free chlorine production of the pool with your usual analysis kit. The free chlorine
must be greater than 1particle by million. If it is not the case, settles the device on the position 10
(100 %) and let run in continuous work until obtaining a sufficient concentration (from few hours to
few days).
 As soon as the free chlorine is greater than 1 particle by million, put the filtration on « AUTO » and
calibrate the time filtration according to the following board :
T(°C) 16
Time (h) 8

Calibrate the production % so as to maintain the free chlorine level in the pool between 0,5 and 1
particle by million. In the starting up, in first estimation, adjust with the following values :
30 3 Model
m
Pool volume ( 3 )
m
3
30 m
3
25 m
3
20 m
3
15 m
3
10 m
Note : Every use of pool is different, it could be necessary several tests to determine the most adapted value to the
situation.
MINISALT – PAPI004086MULTI1- FR/EN/ES/DE – Rev.03.14
0 - 5
16
18 20
9 10
Setting of % Pool volume (
50 m
00
09 45 m
40 m
08
07 35 m
30 m
06
Your device is now ready.
5 - 12 12 - 20
10 8
Co
26
22 24
13
11 12
50 3 Model
m
3 ) Setting of %
m
3
10
3
09
3
08
3
07
3
06
20 - 40 40 - 60
6 4
; the chosen state is registered and
V
28 30
16 19
70 3 Model
m
Pool volume ( 3 )
m
3
70 m
3
65 m
3
60 m
3
55 m
3
50 m
> 60
2
.
V
-
+
More
24/24
Setting of %
10
09
08
07
06
22