Dell EMC PowerEdge R940xa Handbuch Seite 7

4. Route the Slimline cable through the cable holder on the riser.
5. Lift the PERC card from slot 7 to disengage it on the system board and
remove the mini SAS cable from the card.
6. Press and release the PCIe latch to lift the PCIe blank from the riser.
7. Align the screw holes on the bracket with the holes on the PERC card and
screw the bracket to the card.
8. Align the PERC card in slot 5 of Riser 1 and push until it is firmly seated in the
slot.
9. Plug the SAS cable to the PERC card.
10. Install the air shroud C into chassis.
11. Align the riser module with the slots on the rear of the system chassis and
slide the riser into place.
12. Tighten the two thumb screws that secure the riser module to the system.
7