Dell EMC PowerEdge R940xa Handbuch Seite 6

For more information about the Memory guidelines, see the General memory module
installation guidelines topic and the Quad CPU Memory population rules table in the
Dell EMC PowerEdge R940xa Installation and Service Manual available at
Dell.com/poweredgemanuals.
NOTE: Insert DIMM blanks wherever DIMM sockets are not used.
Installing the Slimline cable and PERC
card to the riser
Prerequisites
Remove the riser 1 module.
For more information, see your system's Installation and Service Manual available at
Dell.com/poweredgemanuals.
Follow the below instructions for system installed with GPU without NVMe drives:
1. Press and slide the release button to lift the riser cover.
2. Lift and open the card retention latch.
3. Plug the Slimline cable to the riser card aligning the connectors, Riser1_A0,
Riser1_B0, Riser1_C0 of the Slimline cable with A0, B0, C0 connectors on the
riser card.
6