End Of Operation - Taski Swingo 455B Original Bedienungsanleitung

Battery capacity - end of operational readiness
• The battery level indicator notifies
you that the machine is ready for op-
eration.
• Blinking red LED:
2 minutes to finish working before the machine automati
cally switches off.
• Solid red LED:
Requires a full charging cycle.
Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in sev-
eral work steps.
Notice:
The machine guiding might be impaired in
case of special combinations of flooring/
contamination and cleaning product.
Optionally available wheels can improve
the traction of the machine on the floor.
Please contact your TASKI customer con-
sultant.
Replenishing cleaning solvent
Attention:
The flooring may be damaged when work-
ing without cleaning solution.
Notice:
A rattling sound of the pump indicates that
the fresh water tank is empty.
Attention:
The pump must never run dry for an ex-
tended period.
• The machine must be switched off.
• Open the tank lid.
• Fill the fresh water tank with water, see page 67.
• Add the cleaning product using the dosing cup.
• Close the tank lid.
Draining dirty water
• If the recovery tank is full, the floater
will be sucked onto the suction filter.
This will be indicated by a change of
the noise by increasing the suction
speed as well as residual water at the
bottom.
• Drain the recovery tank, see page 70.

End of operation

• Press the Brush drive ON/OFF but-
• Drive on for a few meters so that the brushes keep on ro-
tating for a short time to avoid dripping.
-
Very important for TASKI contact pads!
• To lift the tool, push the foot pedal
• Drive on for a few meters in order to absorb the remaining
drain water.
• Lift the squeegee.
• Press the Suction unit ON/OFF but-
• Switch off the machine.
Attention:
The machine must now be emptied and
cleaned. Switch off the machine (main
switch) and disconnect the battery discon-
nection socket before beginning with the
following steps.
ton.
The cleaning solution supply is
stopped.
downwards until it engages.
Allow the suction unit to run on so
that the remaining waste water in the
hose is sucked up.
ton.
The display lights up; the suction en
gine stops.
EN
-
69