Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from valve(s) at low point(s) of piping,
air filter and compressor tank daily. Install a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling disconnects. See drawing 16578775 and table on page
2. Maintenance frequency is shown in a circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air Filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
* Measurement for remote tools with included tube fittings is for tube OD.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts be separated by material so that
they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
Model Identification
QA
4
A
A
L
L Lever
A Angle
R Remote
S In-Line
M Power Unit
Z Offset
EN-2
6. Thread size
7. Coupling
8. Safety Air Fuse
9. Oil
S
01 1
Angles
S ASO
Lever
D Direct Drive
011
N 1/4" NP T
015
B 1/4" BS P
020
Remote
030
N 3/8" Tube
040
055
B 10mm Tube
In-Lines
012
015
020
027
046
N
P
P Standard
25 = 25 mm Head
Gearcase
28 = 28 mm Head
35 = 35 mm Head
F Flanged
20 = 25 mm Spindle, no float (solid)
Mounting
21 = 50 mm Spindle, 19 mm float
41 = 100 mm Spindle, 19 mm float
61
81
25
S
S Square
Q Quick Change
(Female Hex.)
= 150 mm Spindle, 38 mm float
= 200 mm Spindle, 38 mm float
04
04 1/4"
06 3/8"
08 1/2"
80160336_ed6
Werbung
Inhaltsverzeichnis
