Attaching the Battery Adaptor
These instructions give the steps for attaching the
battery adaptor to the CA-550/550P. The battery
adaptor can be attached by screws or by the supplied
attachment (supplied as an assembly).
Notes
• The back tally lamp is not visible when the battery
adaptor is attached to the CA-550/550P.
Screwing the Battery Adaptor
Perform the following procedure to screw the battery
adaptor to the camera adaptor.
1
Remove the caps from the
screw holes on the camera
adaptor rear surface.
2
Take out the hexagonal wrench
stored in the battery adaptor.
3
Screw the battery adaptor to
the camera adaptor using the
hexagonal wrench. Connect
the DC power cord to the DC
IN connector on the camera
adaptor.
4
Put the hexagonal wrench
back.
• When attaching the battery adaptor to the CA-57A/
57AP, a plate with screw holes for the CA-57A/57AP
is required (not supplied).
For more information, contact qualified Sony service
personnel.
Note
This method cannot be used with the CA-55A/55AP.
Camera adaptor
Caps
Hexagonal
wrench
Back side
To DC IN
DC power cord
3(E)