Installation
Attaching the CBK-PC01
Note
Turn the camcorder's POWER switch
off before installing the CBK-PC01.
1
Loosen the four screws (+B2.6 ×
10) that hold the WRR cover plate
to the camcorder, and remove the
cover from the camcorder.
The screws are drop-proof and will
not become separated from the
cover plate.
2
Pull out the WRR installation
assembly from the slot of the
camcorder.
Pressing the WRR installation
assembly towards the rear side of
the camcorder will make it easier
to take out.
16
Installation
Note
Put the WRR cover plate and the
WRR installation assembly aside
for later use, as they will be
required when attaching a WRR-
855 UHF Synthesizer Tuner Unit.
3
Insert the CBK-PC01 into the slot.
Be sure to insert the CBK-PC01
slowly to avoid damaging the
connector.