Attachment And Connections; Attaching The Receiver/Tuner Unit; Attaching To/Detaching From The Camcorder - Sony DWA-01D Bedienungsanleitung

Attachment and
connections
Attaching the receiver/
tuner unit
Insert the DWR-S01D or WRR-855 into the
wireless receiver slot.
1
Insert the receiver/tuner unit into the
wireless receiver slot after observing
the direction of the D-sub 15-pin
connector inside the slot and that of the
receiver/tuner unit.
22

Attachment and connections

2
Fasten four mounting screws of the
receiver/tuner unit with a screwdriver.
Note
If any of the screws are loose, weatherproof
structure may not be obtained or
malfunction due to vibration may occur.
Attaching to/detaching
from the camcorder
Use the DWA-01D to mount the wireless
receiver on the rear of the Sony camcorder.
In order to do so, an optional mount bracket
(A-8278-057-B) and the mount plate
supplied with the DWA-01D are required.
To detach the DWA-01D from the mount
plate, push the release lever on the mount
plate.
BP-GL95/GL65/L80S/
L60S battery pack
(not supplied)
Mount bracket (A-8278-057-B)
(not supplied)
Phillips screwdriver
To connect the power cable
Using the DC power cable supplied with the
DWA-01D, connect the DC IN connector to
the DC OUT connector of the camcorder.
To connect the audio cables
For the camcorder that accepts
analog audio only
Use the audio cables supplied with the
DWA-01D to connect the OUTPUT1 and 2
Mount plate
(supplied)