Maintenance, Servicing, And Storage; Specifications - 3M NANO-LOK 3500224 Benutzeranleitung

5.6 DISPOSAL: Dispose of the Nano-Lok Edge SRL if it has been subjected to fall arrest forces or inspection reveals an
unsafe or defective condition. Before disposing of the SRL, cut the cable lifeline in half or otherwise disable the SRL to
eliminate the possibility of inadvertent reuse.

6.0 MAINTENANCE, SERVICING, AND STORAGE

6.1 CLEANING: Cleaning procedures for the Nano-Lok SRL are as follows:
• Periodically clean the exterior of the SRL using water and a mild soap solution. Position the SRL so excess water can
drain out.
• Clean the cable lifeline (and WrapBax web lifeline) with water and mild soap solution. Rinse and thoroughly air dry.
Do not force dry with heat. The cable lifeline should be dry before allowing it to retract into the housing. An excessive
buildup of dirt, paint, etc. may prevent the lifeline from fully retracting back into the housing and create a potential
free fall hazard.
If the lifeline contacts acids or other caustic chemicals, remove the SRL from service and wash
i
with water and a mild soap solution. Inspect the SRL per Table 1 before returning to service.
6.2 SERVICE: Nano-Lok Edge SRLs are not repairable. If the SRL has been subjected to fall arrest forces or inspection
reveals an unsafe or defective condition, remove the SRL from service, mark "UNUSABLE", and dispose of in the
recommended manner (see "Section 5.6 - Disposal").
6.3 STORAGE: Store Nano-Lok Edge SRLs in a cool, dry, clean environment out of direct sunlight. Avoid areas where
chemical vapors may exist. Thoroughly inspect the SRL after any period of extended storage.

7.0 SPECIFICATIONS

7.1 PERFORMANCE: Nano-Lok Edge SRLs have been tested and certifi ed to the performance requirements of the
standard(s) identifi ed on their ID labels. See "Section 2.0 - Limitations & Requirements" for performance specifi cations.
7.2 MATERIALS: Material specifi cations for the Nano-Lok Edge SRL are as follows:
Housing:
Drum:
Fasteners:
Locking Pawls:
Main Shaft:
Harness
Connector
End Connectors
(See Figure 1):
Super Tough Nylon, UV Resistant
Aluminum Alloy
Zinc Plated Alloy Steel Screws;
Stainless Steel Rivets
Stainless Steel
Stainless Steel
Aluminum Alloy Frame and Alloy Steel Locking Pin
G 2000023 Aluminum Alloy Captive Eye Carabiner
H 2000209 Aluminum Alloy Rebar Snap Hook
I 2007153 Aluminum Alloy Rebar Snap Hook
J 9502116 Alloy Steel Snap Hook
K 9500943 Alloy Steel Rebar Snap Hook
L 2000210 Alloy Steel Rebar Snap Hook
M 9501804 WrapBax Alloy Steel Rebar Snap Hook
N Loop End
O 2000188 Aluminum Alloy Carabiner
Motor Spring:
Swivel:
Lifeline:
Wrapbax Web:
Energy Absorber
13
Stainless Steel
Zinc Plated Steel
3/16" 7 X 19 Galvanized Cable
Kevlar/Dyneema
Web: Vectran/Polyester
Cover: Polyester and Nylon fabric
Stitching: Polyester Thread