Zeiss Primo Star Bedienungsanleitung Seite 8

Carl Zeiss
If it is noted that protection measures are no longer effective, the instrument must be switched
off and safeguarded against inadvertent operation. Please contact a Zeiss service agency or the
Carl Zeiss Microscopy Service to repair the instrument.
Always disconnect the power cable before opening the instrument and changing the lamp
−
or LED.
Wait for the lamp to cool down before replacing it and do not touch the new bulb to avoid
−
fingerprints.
The instrument may be opened by accordingly instructed specialists or service staff only.
−
The operation of the instrument in explosion-risk environments is not allowed.
−
When using immersion oil, read in any case the safety data sheet.
Immersion oil irritates the skin. Avoid any contact with skin, eyes and clothing.
After skin contact, wash the oil off with plenty of water and soap.
After eye contact, immediately rinse the eye with plenty of water for at least five minutes.
If the irritation persists, consult a medical specialist.
Proper disposal of immersion oil: Take care to ensure that immersion oil does not enter surface
water or the sewage system.
The microscope is not equipped with special devices for the protection from substances that
are corrosive, potentially infectious, toxic, radioactive, or other substances that might be
hazardous to health. Make sure to observe all legal regulations, particularly the relevant
national accident prevention regulations when handling such substances.
Before any transportation of the instrument, switch it off and let it cool down (hot surface
−
on the underside of the instrument).
Operate the device only on a hard, non-combustible base.
−
The plug-in power unit must not get in contact with moisture.
−
8
Notes on Instrument Safety
415500-7344-008
Primo Star / Primo Star iLED
11/2013