Power Saving; Electrical Circuit Diagram - Baxtran STA Betriebsanleitung

CHECk BATTERY
I
Press
II
Press
III
Press
kEEP THE WEIGHT READING
Press HOLD key on controller to maintain the weight reading on the display. Now, "HOLD" light is on. Press this key again to turn
off this function.
LoW BATTERY WARNING
When the battery voltage is lower than
voltage, it will show
use again.
oVERLoADING WARNING
The display will show
city range, otherwise it's very dangerous.

PoWER SAVING

The display will show
load changes. When the load are at stable status in excess of 60 minutes, the weighing hook will turn off automatically.
BATTERY RECHARGING
1. Turn off, connect the adapter with 220V AC power supply, also insert the plug in the socket which located in the rear of scale. The
light become orange, it means it's recharging automatically, until the orange light become red, that means recharging is finished.
2. When you need to use weighing hook hour after hour, take off the rear cover, change the battery with rcharged battery.
ATTENTION: Generally, the time of recharging should not lower than 8 hours, this hook have recharging protection function, long
time recharging will not damage the battery.
TURN oFF
I
Press
II
Press
III
After 15 minutes of stability, display will show
7. ELECTRICAL PRINCIPLE DIAGRAM
32
on scale, when turn on or turn off, it shows
on controler, when turn off, it shows
and continue to press
, after 1 minut, the weighing hook will turn off automatically. You need to recharge the battery to
, once the load (Net+Tare) exceeds Max. Capacity. Make sure that the load are within the capa-
when the load are at stable in excess of 15 minutes and revert to normal weighing readings when
on the weighing hook during 2 seconds.
on the controller during 2 seconds.
USER'S GUIDE | WEIGHING HOOK | STA
.
, it shows , press
, the display flash, but the weighing hook can still work until to permit lowest
after 60 minutes the weighing hook will turn off automatically.
.
return.
EN