Operation; Power On/Off; Zero; Tare - Baxtran XTA series Bedienungsanleitung

DISPLAY OVERLAY
DISPLAY SYMBOLS
BATT
Net
Stable

Zero

/Kg or /100g
SAVE
CHARGE
CH

6. OPERATION

INITIAL START-UP
Warm-up time of 15 minutes stabilizes the measured values after switching on.

6.1 POWER ON/OFF

Power switch is located below the right side of the scale. Switch on the scale by pressing on/off. The display is switched on and the
self test is started. If you want to switch off press again the key.
6.2 ZERO
Environmental conditions can lead to the balance exactly zero in spite of the pan not taking any strain. However, you can set the display
of your balance to zero any time by pressing
inside metrological margins.

6.3 TARE

The weight of any container can be tared by pressing
weighed is always displayed.
10
Battery indicator. When it's illuminated, battery should be recharged.
Net weight.
Stable indicator. When it's illuminated, the scale is stable.
Zero indicator. When it's illuminated, the scale is in zero point.
Kilogram or 100g mode.
Save indicator.
Battery charging indicator
Check out indicator
key and therefore ensure that the weighing starts at zero if the desviation is
key, so that with subsequent weighing the net weight of the object being
USER MANUAL XTA EN