Connecting Your Monitor - iiyama AS4314UT Bedienungsanleitung

CONNECTING YOUR MONITOR

A Ensure that both the computer and the monitor are switched off.
B Connect the computer to the monitor with the signal cable. (See page 17 for CONNECTOR PIN
ASSIGNMENT.)
C Connect the AC Adatper to the Connector for AC Adapter of the monitor.
D Connect the Power Cable to the AC Adapter first and then to the power supply.
n The signal cables used for connecting the computer and monitor vary by the type of
NOTE
computer used. An incorrect connection may cause serious damage to both the monitor
and the computer. The cable supplied with the monitor is for a standard 15 pin D-SUB
connector. If a special cable is required please contact your local iiyama dealer or regional
iiyama office.
n For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.
n Make sure you tighten the finger screws at each end of the signal cable.
Signal Cable for
D-Sub Connection (Fixed)
Computer
01-4314ut-E.p65 11
Power Cable
(Accessory)
AC Adapter
(Accessory)
BEFORE YOU OPERATE THE MONITOR
2001/11/22, Χ΋ 03:26
7