Connecting Your Monitor - iiyama Vision Master 1451 Bedienungsanleitung

CONNECTING YOUR MONITOR

A
Ensure that both the computer and the monitor are switched off.
B Connect the computer to the monitor with the signal cable. (See page 13 for CONNECTOR PIN
ASSIGNMENT.)
C Connect the Power Cable to the monitor first and then to the power supply.
n
NOTE
The signal cables used for the connection vary by the type of computers you use. An
incorrect connection may cause serious damage to both the monitor and the computer.
The cable supplied with the monitor is for a standard 15 pin D-Sub connector. If a
special cable is required please contact your local iiyama dealer or regional iiyama
office.
n
For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.
n
Make sure you tighten the finger screws at each end of the signal cable.
BEFORE YOU OPERATE THE MONITOR 7