Connecting Your Monitor - iiyama AX3835UT Bedienungsanleitung

CONNECTING YOUR MONITOR

A Ensure that both the computer and the monitor are switched off.
B Connect the computer to the monitor with the signal cable. (See page 20 for CONNECTOR PIN
ASSIGNMENT.)
C Connect the monitor to the USB compliant computer with the USB Cable when using the USB hub
features.
D Connect the Power Cable to the monitor first and then to the power supply.
n The signal cables used for connecting the computer and monitor vary by the type of computer
NOTE
used. An incorrect connection may cause serious damage to both the monitor and the
computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector. If a
special cable is required please contact your local iiyama dealer or regional iiyama office.
n For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.
n Make sure you tighten the finger screws at each end of the signal cable.
n Cables are connected easily by rotating the panel 90 degrees. (See page 8 for PANEL
ROTATION.)
n Cables can be bundled together inside the cover at the back of the stand. See next page
for cable wiring.
[Example of Connection]
Power Cable (Accessory)
Keyboard
6 BEFORE YOU OPERATE THE MONITOR
< Back >
D-Sub Signal Cable
(Accessory)
USB Cable (Accessory)
Mouse
Printer
DVI-D Signal Cable
(Accessory)
to DVI connector
of computer
to D-Sub connector
of computer
Computer