Computer Setting; Adjusting The Viewing Angle - iiyama AS4314UT Bedienungsanleitung

COMPUTER SETTING

n Signal Timing
When you connect the monitor to the computer for the first time, set the signal timing of the
computer to VGA before connection. Change to the desired signal timings listed on page 17 in
COMPLIANT TIMING, after you confirm that the picture appears normally at VGA.
n Windows 95/98/Me/2000 Plug & Play
The iiyama LCD monitor complies with DDC1/2B of VESA standard. The Plug & Play function runs
on Windows 95/98/Me/2000 by connecting the monitor to DDC1/2B compliant computer with the
Signal Cable supplied. Windows 95/98/Me/2000 Monitor Information File for iiyama monitors may
be necessary for your computer and obtained via the Internet, using the address:
n For additional information on how to download the driver for your touch screen
NOTE
monitor, please access one of the internet sites noted above.
n Monitor Drivers are not required in most cases for Macintosh or Unix operating systems.
For further information, please contact your computer dealer first for advice.

ADJUSTING THE VIEWING ANGLE

n For optimal viewing it is recommended to look at the full face of
the monitor, then adjust the monitor's angle to your own
preference.
n Hold the stand so that the monitor does not topple when you
change the monitor's angle.
n You are able to adjust the monitor's angle up to 25 degrees
upward, 5 degrees downward.
n Do not touch the LCD screen when you change the
NOTE
angle. It may cause damage or break the LCD screen.
n Careful attention is required not to catch your fingers
or hands when you change the angle.
8 BEFORE YOU OPERATE THE MONITOR
01-4314ut-E.p65
http://www.iiyama.com (U.S.A.)
http://www.iiyama.co.uk (U.K.)
12
2 5
5
2 001/11/2 2 , Χ΋ 03:2 6