Use As An Autonomous Cutting Saw Version (Fig. 3-5-7); Maintenance - Storage - Assistance - Disposal - Femi N251DA XL Gebrauchs- Und Wartungsanleitung

4.2.

USE AS AN AUTONOMOUS CUTTING SAW VERSION (Fig. 3-5-7)

a. Secure the workpiece to be cut in the clamp using lever (27).
b. Release the lever (33) to start descent ("FAST DESCENT" to take the blade up to 5 mm
away from the workpiece turn the knob (34) counter-clockwise)
c. Press button (1) to commence work.
d. Let go of the head and wait for cutting to be completed up to the end of the stroke
DANGER - CAUTION
• Never bring hands anywhere near the cutting zone until the head has returned
to its full height and the blade has come to a complete standstill.
• Let the cut piece fall onto the base of the machine.
NOTE
At the end of the work process the machine stops automatically.
e. Lift the head to the required position for the following cut
f. Block the head using the lever (33)

5. MAINTENANCE - STORAGE - ASSISTANCE - DISPOSAL

NOTE
Routine maintenance operations which can be performed by the user are described
below.
Have the machine repaired by expert personnel only. This machine complies with all
the relevant safety prescriptions. Repairs to the machine must be carried out by skilled
personnel only using original spare parts. Failure to observe this recommendation could
jeopardize user safety.
DANGER - WARNING
• BEFORE PERFORMING ANY MAINTENANCE WORK, PLACE THE MACHINE
IN SAFETY CONDITIONS, (SEE HEADING "GENERAL SAFETY RULES").
• PLACE THE POWER CABLE IN A COIL NEAR THE MACHINE.
EN
33