Installation And Adjustment Of Bar Holder (Optional Fig. 4); Cutting Fluid System (Fig. 6); Use; Adjusting Blade Tension (Fig. 3) - Femi N251DA XL Gebrauchs- Und Wartungsanleitung

EN
3.7.

INSTALLATION AND ADJUSTMENT OF BAR HOLDER (OPTIONAL Fig. 4)

a. Install the guide rod (19) in the hole on the base.
b. Tighten nut (20).
c. Slacken the handwheel (21) and position the holder (22) at the required distance.
d. Tighten the handwheel (21).
3.8.

CUTTING FLUID SYSTEM (Fig. 6)

NOTE
To prepare the cutting fl uid, use special
cutting oils indicated in table.
a. Prepare 8.5 litres of water-oil emulsion
(concentration ratio: 10%).
b. Pour the contents directly into the tank of
the pump (30).
DANGER - WARNING
NEVER USE THE MACHINE WITHOUT
CUTTING FLUID.

4. USE

DANGER - WARNING
THE MACHINE IS FITTED WITH A MAINS SWITCH (31 - FIG. 7) TO BE ACTIVATED
BEFORE CARRYING OUT KIND OF WORK OPERATION. ONCE WORK HAS BEEN
COMPLETED, TURN OFF THE MAINS SWITCH (31A - FIG. 7).
DANGER - CAUTION
• Never wear gloves during the machine cutting phase.
• Before commencing a new cut, always remove the cuttings left from the previous
task.
• Keep hands well away from the cutting zone.
DANGER - WARNING
RUNNING IN THE BLADE: PERFORM A CORRECT RUNNING-IN PROCEDURE
AS INDICATED IN THE HEADING "BLADE REPLACEMENT".
4.1.

ADJUSTING BLADE TENSION (Fig. 3)

Turn the handwheel (2) clockwise till reaching the green fi eld "X". Optimum position end of
green fi eld.
DANGER - WARNING
IF THE BAND TENSION IS TOO HIGH THE BELT MAY JUMP OUT OF THE
GUIDES.
32
TABLE OF OILS
BRAND
AGIP
CASTROL
CHEVRON
ESSO
MOBIL
SHELL
TOTAL
IP
TYPE OF OIL
OXALIS
SUPER
EP
KUTWELL
SOLVAC
DROMUS
LACTUGA
UTENS