Adjusting The Feed Speed For The Autonomous Cutting Version (Fig. 7); Correct Positioning Of The Workpiece In The Clamp; Clamp Adjustment (Fig. 5) - Femi N251DA XL Gebrauchs- Und Wartungsanleitung

3.3. CUTTING SPEED ADJUSTMENT (Fig. 7A)
NOTE
Adjust the cutting speed as indicated in this manual. The device for regulating speed
depends on the specifi c machine model.
Select the speed using the switch (32).
3.4. ADJUSTING THE FEED SPEED
FOR THE AUTONOMOUS CUTTING
VERSION (Fig. 7)
Select the feed speed by acting on the knob
(34) (turn counterclockwise to increase
speed).
3.5. CORRECT POSITIONING OF THE
WORKPIECE IN THE CLAMP
Position the workpiece to be cut directly
between the jaws, without placing any other
objects between.
DANGER - WARNING
TO POSITION FLAT OR SPECIAL
SHAPED PROFILES, PLEASE REFER
TO THE EXAMPLES PROVIDED IN
THE FIGURES.
IF THE THICKNESS OF THE PROFILE
IS VERY THIN, TO STOP IT FROM
GETTING CRUSHED IN THE JAWS OF THE CLAMP, PUSH A MOULD INTO THE
PROFILE WHICH MATCHES ITS SHAPE.
3.6.

CLAMP ADJUSTMENT (Fig. 5)

To secure the workpiece in the clamp:
a. slacken the slide (24) by moving the lever (27) upwards;
b. Turn the handwheel (28) clockwise to take the slide (24) up to the workpiece until it is just
one millimetre away from it;
c. clamp the piece fi rmly between the jaws by moving the lever (27) down.
NOTE
If you need to cut several pieces from the same bar simply release and retighten the
clamp using lever (27).
To change bar, fi rst release the clamp by moving the lever (27) up and then turn the
handwheel (25) anti-clockwise to move the slide away from the workpiece.
SECTION
<50
>50<100
>100
<3
>3<30
>30
EN
8/12
6/10
4/6
10/14
8/12
6/10
31