Information Concerning Noise And Vibrations; Information On Electromagnetic Compatibility - Femi N251DA XL Gebrauchs- Und Wartungsanleitung

EN
Solid material ejection hazard:
This risk is due to the presence of the rotating tool.
Precautions to be taken
• When working with the tool, always wear the necessary personal protective equipment:
safety goggles, safety shoes.
1.7.

INFORMATION CONCERNING NOISE AND VIBRATIONS

The noise values indicated are emission levels and not necessarily safe operating levels. While
there is a correlation between emission levels and exposure levels, this cannot reliably be used
to determine whether or not further safety precautions are needed.
Factors which infl uence the real level of a worker's exposure include the duration of exposure,
the characteristics of the working environment, other sources of noise, for example the number
of machines or operations being carried out in the near vicinity. Furthermore, levels of safe
exposure may be fi xed differently from one country to another.
This information does however help the machine user to better assess the hazards and
risks.
DANGER - WARNING
IT IS ADVISABLE TO USE SUITABLE HEARING PROTECTION SUCH AS
EARMUFFS OR EAR PLUGS.
Vibrations
The mean frequency-weighted r.m.s. hand-arm acceleration value in normal cutting conditions
using correctly sharpened blades, is less than 2.5 m/sec
Test measurements were carried out in accordance with Standards EN ISO 5349-1 and
5349-2.
DANGER - WARNING
VIBRATIONS DURING REAL MACHINE USE MAY DIFFER FROM THOSE
DECLARED AS THE TOTAL VIBRATION VALUE DEPENDS VERY MUCH ON
HOW THE MACHINE IS USED.
IT IS THEREFORE NECESSARY TO IDENTIFY THE MOST APPROPRIATE SAFETY
MEASURES REQUIRED FOR SAFEGUARDING THE OPERATOR BASED ON
ESTIMATED EXPOSURE TIMES AND REAL CONDITIONS OF USE.
1.8.

INFORMATION ON ELECTROMAGNETIC COMPATIBILITY

Electromagnetic emissions from the machine do not exceed the limits defi ned by the relative
standards for the envisaged conditions of use.
Testing was carried out in accordance with Standards EN 61000-6-2, EN 61000-6-4.
26
.
2