Battery; Battery Charger; Accessories; Installation Information - Comet CPS 55 Handbuch

PHOTO A
1 BATTERY COMPARTMENT HOOD
2 RECOVERY WATER TANK
3 SOLUTION WATER TANK PLUG
4 SOLUTION WATER TANK
5 BRUSH MOTOR PROTECTIVE COVER
6 SPLASH GUARD
7 FRONT RIGHT BUMPER WHEEL
8 MACHINE RIGHT WHEEL
PHOTO B
1 CONTROL PANEL
2 GENERAL ON / OFF KEY SWITCH
3 SOLUTION WATER OUTLET ADJUSTING
LEVER
4 RECOVERY TANK DRAIN HOSE
5 SOLUTION WATER TANK DRAIN PLUG
6 BRUSH PLATE LIFT/LOWER PEDAL
7 RECOVERY TANK INSPECTION PLUG
8 SQUEEGEE LIFT/LOWER LEVER
9 BATTERY CHARGER CONNECTOR
10 FORWARD/REVERSE TRACTION LEVER
PHOTO C
DC 24V MODEL WITH TRACTION
1 FORWARD/REVERSE LED INDICATORS
2 PUSH SWITCH FOR THE ADJUSTING OF
DRIVING SPEED
3 DRIVING SPEED LED INDICATORS
4 BRUSH MOTOR SWITCH
5 SUCTION MOTOR SWITCH
6 BATTERY POWER TEST
PHOTO D
DC 24V MODEL WITH TRACTION
1 GENERAL ON / OFF KEY SWITCH
2 FORWARD/REVERSE TRACTION LEVER
2A FORWARD DRIVE
2B REVERSE DRIVE
3 HOUR METER
4 BRUSH MOTOR
KER
5 TRACTION MOTOR THERMAL BREAKER
6 SOLUTION WATER OUTLET ADJUSTING
LEVER
7 RECOVERY TANK DRAIN HOSE
8 BATTERY CHARGER CONNECTOR
SQUEEGEE LIFT/LOWER LEVER
PHOTO E
DC 24V MODEL WITHOUT TRACTION
1 BRUSH MOTOR SWITCH
2 SUCTION MOTOR SWITCH
3 BATTERY POWER TEST
PHOTO F
AC 230V MODEL
1 GENERAL ON/OFF SWITCH
2 BRUSH MOTOR SWITCH
3 SUCTION MOTOR SWITCH
PHOTO G
DC 24V MODEL
1
2
3
PHOTO H
1
2
PHOTO I
PHOTO L
1
2
3
4
5
6
7
PHOTO M
1
2
PHOTO M
1

5.2.2 BATTERY

If supplied, the Pb-Acid (if not dry charged) or gel bat-
teries are ready to be installed:
Positive pole - red
Negative pole - black

5.2.3 BATTERY CHARGER

If supplied, refer to the corresponding booklet.
THERMAL BREA-

5.3 ACCESSORIES

Your machine supplier can provide a complete
and updated list of all available accessories, such as
brushes, scrapers, disks, etc.

6. INSTALLATION INFORMATION

6.1 BATTERY PREPARATION

• The technical features of the batteries used must
match those indicated in the technical features sec-
tion. Using different batteries may cause serious da-
mage to the machine or may require them to be char-
ged more frequently.
• During installation or when performing any type
of battery maintenance, the operator must be equip-
ped with adequate safety accessories to prevent acci-
dents. Work far from open flames, do not short-circuit
the battery poles, do not generate sparks and do not
smoke.
The batteries are normally supplied full of acid solu-
tion (for the Pb-Acid type) and ready for use. In any
28
SUCTION COMPARTMENT HOOD
BATTERY COMPARTMENT WITH 12V
BATTERIES
BATTERY COMPARTMENT HOOD
DC 24V MODEL
SUCTION FILTER
VACUUM MOTOR COMPARTMENT
DC 24V MODEL
BATTERY CONNECTION DIAGRAM
SUCTION HOSE CONNECTOR
SQUEEGEE INCLINATION ADJUSTING
KNOB
SQUEEGEE BLADES REPLACEMENT
KNOB
SQUEEGEE BUMPER WHEEL
SQUEEGEE PRESSURE ADJUSTING
KNOB
SQUEEGEE WHEEL
SQUEEGEE FIXING KNOB
SPLASH GUARD FIXING SPRING CLIP
SPLASH GUARD
BRAKE LEVER