Werbung
or.
Never use the machine without the detergent solu-
tion: the floor might be damaged.
7.7.5 POST-SCRUBBING OPERATIONS
Cut off the supply of detergent.
Lift the brush unit and turn off the brush motor.
After having completely dried any traces of water
on the surface, wait a few seconds and then lift the
squeegee and turn off the suction motor.
Move to a suitable location to drain the tanks (as de-
scribed in 7.4 and 7.5).
Empty and clean the tanks (see sections 7.4 and 7.5).
Turn off the machine using the key and remove it
from the control panel.
If necessary, charge the battery (see the relative sec-
tion).
7.8
SPECIFIC INSTRUCTIONS FOR THE USE OF
POWER MAINS AC 230V MODEL
The power mains AC 230V machine may be turned on
only if the voltage indicated on the tag corresponds
with the available voltage and that the electrical out-
let is grounded (earthed).
Do not damage the feed cable; do not crush or pull
on it.
• ATTENTION Make sure that the power cable does
not come into contact with the rotary brushes.
• ATTENTION !!! - The power mains AC 230V ma-
chine has parts, which are connected to the cur-
rent; contact with these could cause grave injuries
or even death.
- Before executing any type of operation on the ma-
chine always disconnect it from the electrical source.
- Never touch electric cables that are defective or worn.
- Before gaining access to the electrical system it is al-
ways necessary to disconnect the machine from the
electrical source by removing the plug from the sock-
et-outlet.
- In the case of defective, damaged, or cracked electric
cables, replace immediately with authentic replace-
ment parts.
- The network of connections must be protected from
water spray.
- The patch cord for the connection of the machine
to the mains power must conforms to current safe-
ty rules.
- The electrical system to which the machine is con-
nected must be equipped with a cutout box.
- It is absolutely forbidden to use the machine in prox-
imity to swimming pools or stretches of water.
• EMERGENCY SITUATIONS
In case of emergency:
- Immediately disconnect the machine from the
power mains.
- Immediately apply proper first-aid.
If an accident should occur the machine must not be
put into operation until a technician authorized by the
manufacturer has examined it.
8. MAINTENANCE INFORMATIONS
• Turn the key, remove it from the control panel and
disconnect the battery from the machine wiring.
☞ All work on the electrical system as well as all main-
tenance and repair operations (especially those not
explicitly described in this manual) should be carried
out only by authorised service centres or by speciali-
sed technical personnel who are experts in the sector
and in the pertinent safety regulations.
Performing regular maintenance on the machine, and
carefully following the manufacturer's instructions, is
the best guarantee for obtaining the best performan-
ces and extended machine service life.
8.1 TANKS
Drain the two tanks as described in the relative sec-
tions.
Remove any solid dirt by filling and draining the tanks
until all dirt has been eliminated: use a washing hose
or similar tool to do this.
• Water hotter than 50°, a high-pressure cleaner
or excessively powerful sprays may damage the
tanks and the machine.
Leave the plugs of the tanks open (only while the ma-
chine is not being used) so that they can dry and thus
prevent the formation of foul odours.
8.2 SUCTION HOSE
Detach the suction hose from the squeegee.
Now you can wash the hose and remove any obstruc-
tions.
Firmly insert the hose on the squeegee body.
8.3 SQUEEGEE
• Do not handle the squeegee with bare hands: wear
gloves and any safety clothing needed to carry out
the operation.
Detach the squeegee from the machine and clean it
under running water using a sponge or a brush.
Check the efficiency and the wear on the strips in con-
tact with the floor. They are designed to scrape the
film of detergent and water on the floor and to isolate
that portion of the surface to enhance the vacuum of
the suction motor: this ensures that the machine will
dry very efficiently. Working constantly in this manner
tends to round or to deteriorate the sharp edge of the
strip, thus reducing drying efficiently. This is why the
squeegee strips must be replaced.
To replace the worn blades, follow the instructions in
the relative section. Turn the blades around to wear
down the other sharp corners or to install new ones.
8.4 ACCESSORIES
Remove and clean the brushes or the scraper disks.
• To avoid damaging the floor and the machine, ca-
refully check if foreign matter, such as metallic parts,
32
Werbung
Kapitel
