Herunterladen Diese Seite drucken

Comet CPS 55 Handbuch Seite 25

Vorschau ausblenden Andere Handbücher für CPS 55:

Werbung

☞ Carefully read the "instruction manual" before
starting, using, performing unscheduled or routi-
ne maintenance or any other work on the machine.
• Rigorously comply with all the instructions pro-
vided in this manual and in those for the batteries
and battery chargers (with particular attention to
warnings and danger notices).
The manufacturer will not be held responsible for in-
juries to persons or damage to property due to non-
compliance with the aforementioned instructions.
This machine must be powered only with the safety
extra-low voltage indicated on the technical data plate.
☞ Before using the machine, make sure that each part
is in the correct position.
The appliance is not intended for use by persons (in-
cluding children) with reduced physical, sensory or men-
tal capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
• Do not operate this machine for any other purpose
except for the use for which it was specifically desi-
gned. Evaluate the type of building where it will be
utilised and rigorously comply with the current safety
regulations and conditions.
• Do not use the machine in places without adequa-
te lighting, in explosive environments, when harmful
dirt is present (dust, gas, etc.), on roads or public pas-
sage ways and in outdoor environments in general.
• The machine operating temperature range is +4°C
to + 35°C; when not being used, store the machine in
a dry and non-corrosive environment within a tempe-
rature range of between + 10°C and + 50°C.
When using the machine under any condition the hu-
midity must range between 30% and 95%.
• Never use or vacuum liquids, gases, dry dust,
acids and solvents (e.g. paint thinners, acetone,
etc.), even if diluted, inflammables or explosives
(e.g. petrol, fuel oil, etc.); never vacuum flaming or
incandescent objects.
• Do not use the machine on slopes or ramps ste-
eper than 2%;
for small slopes, do not use the machine sideways,
always handle it with caution and never move
backwards. When transporting (10% max) the machi-
ne on steeper ramps or slopes, be very careful to avoid
tipping and/or uncontrolled accelerations.
The machine can be handled on ramps and/or steps
only with the brush head and squeegee lifted off the
ground.
• Never park the machine on a slope.
☞ Never leave the machine unattended with the key
in and connected; it may be left only after having di-
sconnected it and taken the key out and guaranteeing
against accidental movements and, if necessary, di-
sconnecting it from the electrical power supply.
• Make sure there are no other persons, and children
in particular, in the area where the machine is being
used.
• Do not use the machine to transport persons/
things or to tow objects. Do not tow the machine.
☞ Do not use the machine as a support surface for any
weight for any reason.
Do not block the ventilation and heat dispersion ope-
nings.
• Do not remove, modify or by-pass the safety de-
vices.
• Always use individual safety devices to ensure
operator safety: aprons or safety overalls, non-slip
and waterproof shoes, rubber gloves, goggles and
earphones, and masks to protect the respiratory tract.
Before starting to work, remove necklaces, watches,
ties and other objects that may cause serious injuries.
• Do not insert hands between moving parts.
☞ Do not use detergents that differ from those re-
quired and follow the instructions indicated on the
relative safety sheets. Detergents should be stored
in a place that is inaccessible to children. In case of
contact with the eyes, rinse immediately with copious
amounts of water and, if swallowed, immediately con-
sult a physician.
Make sure that the battery charger power sockets are
connected to an efficient earthing system and that
they are protected by magnetothermal and differen-
tial circuit-breakers.
• Follow the battery manufacturer's instructions and
comply with legal provisions. The batteries should
always be clean and dry to avoid surface leakage cur-
rents. Protect the batteries against impurities, such as
metallic dust.
• If the machine is equipped with gel batteries it is
essential to make sure the run-down indicator (loca-
ted on the panel) is adjusted correctly. Contact your
dealer or refer to the specific paragraph.
• Do not place tools on top of the batteries: they may
cause a short-circuit or an explosion.
• When using battery acid, rigorously respect the
relative safety instructions. In the presence of parti-
cularly strong magnetic fields, evaluate the possible
effect on electronic control devices.
Never spray water on the machine to clean it.
☞ Recovered fluids contain detergents, disinfectants,
water, as well as organic and inorganic material col-
lected during work operations: dispose of them in ac-
cordance with current legal provisions.
• If the machine malfunctions and/or operates ineffi-
ciently, turn it off immediately (disconnecting it from
the electric power supply or from the batteries) and
do not tamper with it.
Contact one of the manufacturer's technical service
centres.
• All maintenance or accessory replacement opera-
tions must be carried out in environments with ade-
quate lighting and only after having disconnected the
machine from the electric power supply by detaching
the battery connector.
25

Werbung

loading

Diese Anleitung auch für:

Cps 65