Herunterladen Inhalt Inhalt Diese Seite drucken

Recycling And Disposal; Mounting; Scope Of Delivery; Selecting The Installation Site - Vaillant ecoLEVEL Bedienungsanleitung

Kondenswasserpumpe
Vorschau ausblenden Andere Handbücher für ecoLEVEL:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 19
3 Information on installation and operation

4 Mounting

3.3

Recycling and disposal

Both the pump and its packaging are primarily made of
recyclable raw materials.
Appliance
Neither the pump, or any of its accessories belong in the
household waste. Make sure the old appliance and any
related accessories are disposed of properly.
Packaging
Please leave the disposal of the transport packaging to
the technician who installed the appliance.
4
Mounting
4.1

Scope of delivery

Description
Condensate pump
Wall plugs
Screws
Feed hose
Discharge hose
Wall bracket
Wall bracket for drain hose -
Operating, Installation, and
maintenance manuals
Table 4.1 Scope of delivery
The following tools are required for installation:
- Drill
- Drill bit (6 mm)
- Slot head screwdriver
- Water-level
- Cutting blade
- Tools for making electrical connections
4.2

Selecting the installation site

The ecoLEVEL condensate pump should be installed in
the room where the boiler is located.
The ambient room temperature must be between 5 °C
and 60 °C.
The pump should be fixed to a wall that is suitable for
installation using the provided mounting hardware. If a
suitable wall is not available, a suitable mounting surface
must be prepared.
The ecoLEVEL condensate pump should not be used as
a storage shelf.
4
Dimensions
Quantity
180 x 160 x 100 mm
1
6 mm
2
4 x 35 mm
2
Ø 24 mm x 1.15 m
1
Ø 10 mm x 6 m
1
-
1
6
-
1
4.3

Dimensions and clearances

min. 5 mm
min. 5 mm
90 mm
100 mm
Fig. 4.1 Dimensions and installation spaces
4.4

Installing the wall bracket

• Slide the pre-assembled wall bracket downward and
out of the condensate pump housing.
• Install the wall bracket (as shown in Fig. 4.2) in a suita-
ble position below the point where the condensate
drains out of the boiler.
The wall bracket must be installed in a level position!
Use a spirit-level!
• From above, slide the condensate pump straight down
along the guiding edges of the wall bracket.
A small hook at the lowest position catches the pump
and secures it in the wall bracket.
Note!
The condensate pump can be fastened to the
wall bracket (as shown in Fig. 4.1) either on its
narrow or on its wide side.
Installation and maintenance manual ecoLEVEL 0020010507_02
min. 5 mm
165 mm
175 mm
min. 5 mm

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis