Remove Internal Packaging - HP LaserJet 9000n Inbetriebnahme

Step 4

Remove internal packaging

Remove all packaging from the printer.
WARNING! This printer weighs approximately 63.5 kg (140 lb). HP recommends
that four people move it to avoid injury to you and damage to the printer.
To remove internal packaging
1
2
3
4
5
Note Save all packing material. You may need it to repack the printer at a
later date.
10 Printer setup
Remove all orange packing material from the exterior of the
printer and remove any cardboard or styrofoam material that is
not orange.
Remove all orange packing material from the standard output bin
and the protective film from the display.
Open the left-side door and remove the two packing fuser
spacers. Orange tape connects fuser spacers to the outside of
left door. Remove the orange tape from the fuser shipping locks
to the outside of the door. Close the door after removing the fuser
spacers and the tape.
Open the trays, remove any orange packing material, and close
the trays.
Open the front door and remove the orange packing tape at the
front transfer roller area and on the lock lever for the print
cartridge. Close the door.
ENWW