Fcc Regulations - HP LaserJet 9000n Inbetriebnahme

FCC regulations

This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Note Any changes or modifications to the printer not expressly approved by
HP could void the user's authority to operate this equipment.
Use of a shielded interface cable is required to comply with the FCC
rules.
36 Printer setup
Reorient or relocate the receiving antenna.
Increase separation between equipment and receiver.
Connect equipment to an outlet on a circuit different from that to
which the receiver is located.
Consult your dealer or an experienced radio/TV technician.
ENWW