General Warnings - Jacuzzi young collection project Bedienung Und Wartung

GENERAL WARNINGS

I Jacuzzi
® whirlpool baths are suitable for domestic or similar use
and must not be installed outside.
I We recommend that you fill the bath with water previously
mixed to a maximum temperature of 60 °C (that is, not boil-
ing water first and then cold water), in order to minimise the
formation of scale (which is encouraged by high water tem-
peratures) and maintain the gloss of the surfaces.
I Never start the hydromassage if the cover of the suction intake
is dismantled.
I Remember that it is dangerous to use or reach out for electrical
equipment (radio, hair drier, etc.) when you are in the bath.
I At the end of the hydromassage, it is recommended that you switch
off the general switch installed on the supply line to the tub.
In models AIR, DUO and DUO+DISI, wait for the phase for
expelling water from the pipes connected to the blower to come
to an end. This phase starts about 30 minutes after draining
the tub. See the chapter on the blower.
If you do not want to wait, start the function manually after
draining the tub, then turn off the main switch.
I When the tub is used as a normal bathtub, remember that af-
ter draining it you need to clean the pipes connected to the
blower (nozzles located on bottom of tub) by doing the fol-
lowing:
- turn on the main switch located on the power supply line of
the tub;
i
1
- press key "A" ( ): the blower will come on for 30 sec-
onds and the residual water in the pipes will be expelled.
- turn off the main switch.
17