Jacuzzi young collection project Bedienung Und Wartung Seite 15

IN CASE OF DIFFICULTY...
I The hydromassage does not start
•
Check that the main switch on the power supply line to the
bath is on (see installation manual).
•
Make sure you hold your finger on the key for at least half
a second, otherwise the command will not be accepted.
Insufficient amount of water in the tub
If the amount of water is insufficient, the LED for the start key
of the hydromassage comes on and an acoustic signal lasting
about 30 seconds indicates the error.
•
Fill the tub up to the required level and then follow the in-
structions in the chapter "The Hydromassage".
I The hydromassage stops by itself
Check that the electrical power supply has not been cut off.
The length of the hydromassage has been set in the factory to be
about 20 minutes, so that after this time the cycle stops by itself.
•
Press the appropriate key again if you want to re-start the cycle.
If for any reason the level of water drops below the minimum lev-
el, the pump will shut down and the cycle will automatically come
to an end. The LED for the key will flash for about 2 seconds and
an intermittent acoustic signal of about 2 seconds will indicate
that there is an error.
•
Fill the tub as required and press the appropriate key again
if you want to re-start the cycle.
I The blower (which generates air bubbles) does not start
•
Follow the instructions for the hydromassage function.
I The blower (which generates air bubbles) stops on its own
•
Follow the instructions for the hydromassage function.
I Disinfection does not start
•
Follow the instructions for the hydromassage function.
Also:
Insufficient amount of J-MX 07 liquid
If the level sensor detects a lack (or a paucity) of liquid disin-
fectant in the tank, the LED for the disinfectant key flashes for
about one minute.
•
If you fill the tank with liquid disinfectant within this time, the
cycle starts. Otherwise it will be reset to zero.
I Disinfecting is interrupted
If for any reason the water drops below the minimum level, the pump
will shut off and the function will stop automatically, while the LED
for the disinfecting key flashes for about 5 minutes.
•
If you fill the tub with the required water within this time, the
cycle will start again. Otherwise it is reset to zero.
If the reservoir runs out while J-MX 07 liquid is being pumped
into the water circuit, the cycle is interrupted (the pump shuts
down). The corresponding LED flashes for about 5 minutes and
an acoustic signal indicates the intervention of the system.
•
If you fill the J-MX 07 reservoir within this time, the cycle will
start again. Otherwise, it will be reset. The LED will continue
flashing for another hour in order to indicate that the cycle has
not been completed.
I The display does not receive commands
If two keys are accidentally pressed at the same time, no func-
tion is activated.
•
You will need to wait three seconds before giving a new
command.
If the display is covered by a layer of water, it may not receive
commands.
•
Just wipe the water off with the palm of your hand and wait
about 3 seconds before giving another command.
15