Front View; Hot Surfaces; General Description - Stuart HM50C Bedienungsanweisung

Safety Advice Before Use
 Never move or carry the unit while it is in use
or connected to the mains supply.
 Do not touch the heating element or any
glass vessel whilst in use.
 Only use flasks corresponding to the correct
capacity of your heating mantle.
❖ Do not use the units with flammable liquids
or in a hazardous atmosphere.
 Do not immerse the unit in water or fluids.
 Always fill the glassware/vessel away from
the heating mantle and ensure there is no
liquid on the outside of the vessel before
placing it in the mantle. If spillage does
occur, disconnect from the mains supply and
follow the instructions as detailed in
Maintenance & Servicing.
 Do not cover the mantle while in use.
 Do not block or obstruct the ventilation slots.
 Do not leave the equipment switched on
without a charged flask.
 Do not position the unit such that it is
difficult to disconnect it from the mains by
removing the mains cable from the socket at
the back.

Hot Surfaces

WARNING: The product may be HOT.
Never move or carry the product until it
has been disconnected from the electricity
supply and allowed to cool.

General Description

The Stuart heating mantles have been specifically
designed for heating fluids in round bottomed
flasks. Heating control is provided by a built-
in solid state simmerstat (50, 100, 250 and
500ml mantles) or an energy regulator (1000
and 2000ml mantle). The maximum element
temperature is 450ºC.The mantles are housed in
an aluminium case with stove paint finish to give
good chemical resistance. The units are provided
with ventilation slots in the base and around the
rim to allow convection cooling. All mantles also
have a support rod positioning clamp at the side
of the unit.
Controls

Front view

Heating element
Heating control
Mains power
on indicator
Rear view
Hot surface warnings
Mains input IEC socket
Support rod
bracket
knob
Heating element
on indicator
Refer to
instruction
manual label
Rating plate
Protective
conductor
terminator
3