Landing Gear Installation; Required Adhesives - E-FLITE Carbon-Z cub Bedienungsanleitung

EN

Landing Gear Installation

Required Adhesives:

Thread Lock
Assembly
1. Install 2 tundra tires (A) on the main strut (B) using 4 wheel collars (C) as
shown. Ensure the set screws (D) are aligned with the fl at spots on the
strut. Apply threadlock and tighten.
2. Compress the legs of the strut assembly and insert the top of the assembly
into the slot (E) in the bottom of the fuselage. The strut is fully installed
when the L-bend (F) is completely recessed in the fuselage.
3. Push the legs of the fairing strut (G) together and install it in the rear slot
(H) in the fuselage as was done with the main gear strut.
4. Install the left and right strut brackets (I) (marked L and R) in the respective
slots on the bottom of the fuselage using 4 screws (J).
5. Install the left (K) and right (L) fairings on the respective sides of the fairing
strut, then install the fairings on the main gear strut.
Where needed, disassemble in reverse order.
8
D D
A
F
E
J
I
L
C
B
G
H
K
®