Troubleshooting Guide As3X; Possible Cause - E-FLITE Carbon-Z cub Bedienungsanleitung

Troubleshooting Guide AS3X

Problem

Possible Cause

Flying over recommended
airspeed
Damaged propeller or
spinner
Imbalanced propeller
Flight condition variations
Motor vibration
Oscillation
Loose receiver
Loose aircraft controls
Worn parts
Irregular servo rotation
Splines of prop, spinner and
back plate do not align
If oscillation persists...
Trim is not at neutral
Inconsistent fl ight
performance
Sub-Trim is not at neutral
Incorrect response Incorrect direction settings
to the AS3X Control in the receiver, which can
Direction Test cause a crash
Reduce air speed
Replace propeller or spinner
Balance the propeller. For more information, view John Redman's propeller balancing video at www.
horizonhobby.com
Adjust gain to current fl ight conditions (wind, updrafts, local conditions [elevation, humidity,
temperature, etc.])
Replace parts or correctly align all parts and tighten fasteners as needed
Align and secure receiver in fuselage
Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)
Adjust gain to compensate for parts wear or replace worn parts (especially propeller, pivot points or
servo)
Replace servo
Align the part splines to run smooth at full power
Decrease gain (refer to receiver manual)
If you adjust trim more than 8 clicks, adjust the clevis to remove trim
No Sub-Trim is allowed. Adjust the servo arm or the clevis
DO NOT fl y. Correct the direction settings (refer to the receiver manual), then fl y.
Solution
EN
21