E-FLITE Carbon-Z cub Bedienungsanleitung Seite 13

Wing Installation continued
Installation
1. Slide the wing tube (A) into the fuselage.
2. Install the left and right wing (B and C) over the wing tube and into the
wing slot of the fuselage.
3. Connect the servo connectors (D) to the respective connectors on the
fuselage (connectors are marked AIL or FLAP).
NOTICE: Always put excess servo connector wire into the pocket of the wing to
prevent pinching of wires or other damage.
4. Secure the wings on the fuselage using 2 long screws (E) in the front
holes and 2 shorter screws (F) in the rear holes in the top of the wings.
5. Install the 2 wing struts on the fuselage mount (G) using 2 pins (H) and 2
R-clips (I).
Removal
We recommend removing the wings from the fuselage for storage or transport
of the aircraft.
TIP: Remove the vertical bracket pins and clips from the struts to
pivot the brackets and struts down to the wings. Wing struts do not
need to be disassembled to be removed.
NOTICE: Always secure loose parts after removal. DO NOT FLY if parts are
missing or damage may result.
A
D
C
F
G
EN
B B
E E
H H
I
13