Horizontal Tail Installation - E-FLITE Carbon-Z cub Bedienungsanleitung

EN

Horizontal Tail Installation

1. Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the
control horn faces down.
3. Install 4 screws (B) in the front and rear holes in the bottom of the
horizontal tail.
4. Attach the ball link (C) to the elevator control horn's outermost hole using
the included nut (D) and screw (E).
5. Ensure the elevator servo arm is in the correct position, then adjust the
linkage to center the elevator.
When needed, disassemble in reverse order.
Tip: Use needle-nose pliers or ball link pliers (RV01005) to remove or
install a link on a control horn.
10
A
B
C C
D
E E
®