Operations For Wall Installation - AERMEC MVASZC Anleitung

EN
5.6.

OPERATIONS FOR WALL INSTALLATION

This accessory is designed for wall installation; the following images show the operations to be performed for the correct installa-
tion of the MVASZC control panel:
Phase
Before installation, make sure that the power supply cables and the ones related to the serial communication
arrive at the recess where the recessed box will be installed (using a proper conduit or equivalent systems);
1
WARNING: the power supply and the serial signal must arrive in separate conduits in order to avoid electro-
2
Make sure to separate the touch screen panel from the rear cover, levering the panel's edge with a long
3
GENTLY apply the panel, paying attention to the flat connector that connects the touch screen panel to the
4
5
6
Connect the power supply and the serial cable to the rear cover (supply for L and N terminals, serial cable for
7
8
9
10
11
30
1
8
9
(fixing the earthing wire to the case of the recess box, using the supplied screw)
screwdriver (this operation must be performed with extreme care so as to avoid damaging the device)
Detach the touch screen panel from the plate, removing the connector from the panel
Fasten the rear cover to the recessed box that was previously mounted, using the two supplied screws
Reconnect the touch screen panel's connector to the board on the rear cover
Hook the panel to the cover starting from the upper side and pressing lightly until the two parts are
2
7
10
Description
magnetic disturbances
Mount the recessed box on the wall
rear board
G1 and G2 terminals)
completely coupled
3
6
To remove the panel, per-
form in reverse order the
installation operations
11
4
5