I Replacing The Diaphragm; I Storage And Wintering - Zodiac KONTIKI 2 Montage- Und Gebrauchsanleitung

4.3 I Replacing the diaphragm

Before starting this operation and to avoid serious injury:
• Turn off the filtration pump.
• Disconnect the cleaner from the hose assembly.
• Disconnect the external exhaust hose (
( ) of the external exhaust hose.
• Unscrewing the external exhaust hose.
• Push on the transparent internal exhaust hose (
• Remove the damaged diaphragm together with its suction valve (
To fit the new diaphragm, follow the above steps in reverse order:
• Fit the suction valve ( ) to the new diaphragm (
( ).
• Pull on the transparent internal exhaust hose to replace the diaphragm in its housing and retighten the external ex-
haust hose ( ).
• Replace the assembly in the cleaner body (
to the stop until it is fully locked in place.
4.4 I Storage and winterizing
• For winterizing, drain off all the water from the cleaner (damage caused by frost is not covered by the warranty).
• Clean the whole device and the hoses in clean water then leave to dry.
• Store the device in a dry place which is protected from freezing conditions. Store the cleaner on its side or back to
avoid damage to diaphragm.
• Remove all the connectors and adaptors from the suction line or the skimmer.
Tip: Preserve the condition of the hoses during storage
When the cleaner is stored away, even for short periods, avoid rolling the hoses: they may take on a shape
which may harm the cleaner's performances.
) and the cartridge ( ) from the cleaner body (
) to reveal the diaphragm (
).
) and the diaphragm to the transparent internal exhaust hose
) and retighten the ring on the external exhaust hose (
) by unscrewing the ring
).
) by forcing it
: External exhaust hose
: Ring
: Cartridge
: Internal exhaust hose
: Cleaner body
: Suction valve
: Diaphragm
EN
13