Viscount Prestige 100 Kurzanleitung Seite 37

8. [M.SOLO] button: these buttons control the status of the MIDI Solo function for Man.III
(8A), Man.II (8B) and Man.I (8C). By activating this function, on the instrument connected to
the [MIDI OUT] port only the highest note of those pressed down will sound (monophony with
priority given to the highest note).
NOTE
The monophonic notes generated by the MIDI Solo are only sent on MIDI channel B.
For a detailed description of the MIDI channels controlled by the organ see the "Advanced
Manual".
9. [ENC] button: pressing this button activates the Enclosed function used to control the organ's
general volume by means of the [MAN.III] pedal.
10. [A.P.] button: this button enables the Automatic Pedal, used to play the voices of the pedal
board using the first 32 notes of Man.II. In this case, the organ pedal board is deactivated and
the voices become monophonic, with priority given to the lowest note.
11. [T] button: "Tutti" button, which turns on a preset series of voices and couplers.
The voice composition of the 'Tutti' function is programmable. To save a new set up, switch on
the voices and couplers of your choice, press [S] and, keeping it pressed down, then press
button [T] or the [TUTTI] foot piston.
12. [C] button: "Cancel" button, which switches off any voices, couplers and buttons on the manual
divisionals which may be on and turns the HR buttons on.
13. Floppy disk drive: use only 720 Kb or 1.44 Mb 3.5" floppy disks.
NOTE
The Automatic Pedal and Enclosed will not be turned off by the Cancel button if saving these
two controls programmed in the general memories (see also par. 4.3).
Quick Guide - Viscount Prestige 100
35