Pentair FLECK 7700 Bedienungsanleitung Seite 21

E
N
G
L
I
4.1
S
4.1.1
H
4.1.2
20
4 - VALVE OPERATION
Timeclock regeneration
The number of days between each regeneration cycle is preset. Once reached, regeneration is
triggered at the programmed time.
7 day chronometric regeneration
The regeneration is based on the days of the week: Monday, Tuesday,... Sunday. The electronics
will trigger a regeneration based on the defined days of the week at the set time.
Metered regeneration
The valve calculates the amount of water it can soften between 2 regenerations based on the
exchange capacity (m 3 °tH) and inlet water hardness that are preset.
Immediate or meter delayed regeneration valves
As softened water is used, the remaining volume display will decrease until reaching its reserve
capacity (meter delayed regeneration) or until zero (immediate metered regeneration). When
this happens, regeneration is automatically triggered either straight away or at a preset time.
Service
Service display
In operation, the time of the day and the volume remaining will alternatively be displayed (except
for the time clock version: only the time of day will be viewed).
Time of day
Time of day setting
Set the time of day minute by minute by pressing the
to set quickly the time of day.
Remaining Volume: 765 1
If the remaining volume is higher than 9999 litres, the letter
« t » will appear to indicate that the indicated number must
be multiplied by 1000.
i.e. t 15 = 15 *1000 = 15 000 litres capacity.
In delayed metered regeneration, this display indicates that
the remaining capacity is exhausted. The service position
L.E.D will flash and a regeneration cycle will start at the
programmed time.
Day of the week
or button. Press and hold the button
7700