Lincoln Electric LINC FEED 45 Bedienungsanleitung Seite 6

4. Set Knob: Changes the value on the MSP4 display.
5. Left Button: Changes the MSP4 display to show the
Weld Mode or Arc Control.
6. 12-pin Connector: Connector for a remote control
and a push-pull gun.
7. Water Cooling Line: Warm water from torch.
8. Water Cooling Line: Cool water to torch.
9. EURO Connector.
10. Right Button: Changes the MSP4 display to show
Start Options or End Options.
11. Set-Up: Lights when feeder is set-up.
12. Thermal: Lights when the drive overheats.
13. Right Knob: Adjusts values in the right display.
14. Right Display Window: Shows Voltage or Trim.
Figure 2.
1. Gas Connector: Connection for gas line.
2. 5-pin Connector: ArcLink connection to power
source.
3. Fast-Mate Adapter: Input power connection.
4 - 5. Quick Connect Couplings: If water cooled
torches are used, connect water lines from
water cooler here. Refer to torch and water
cooler guidelines for recommended cooling
liquid and flow rates.
Figure 3.
English
1. Wire Drive: 4-Roll wire drive compatible with 37mm
drive rolls.
2. Cold Inch / Gas Purge Switch: This switch enables
wire feeding or gas flow without turning on output
voltage.
3. Wire Spool Support: Maximum 15kg spools.
Accepts plastic, steel and fiber spools onto 51mm
spindle.
The Linc Feed wire feeders must be used with the door
completely closed during welding.
Not use handle to move the Linc Feed during work.
Loading the Electrode Wire
Open the side cover of the machine.
Unscrew the fastening cap of the sleeve.
Load the spool with the wire on the sleeve such that the
spool turns clockwise when the wire is fed into the wire
feeder.
Make sure that the spool locating pin goes into the fitting
hole on the spool.
Screw in the fastening cap of the sleeve.
Put on the wire roll using the correct groove
corresponding to the wire diameter.
Free the end of the wire and cut off the bent end making
sure it has no burr.
Sharp end of the wire can hurt.
Rotate the wire spool clockwise and thread the end of
the wire into the wire feeder as far as the Euro socket.
Adjust force of pressure roll of the wire feeder properly.
Adjustments of Brake Torque of Sleeve
To avoid spontaneous unrolling of the welding wire the
sleeve is fitted with a brake.
Adjustment is carried by rotation of its screw M10, which
is placed inside of the sleeve frame after unscrewing the
fastening cap of the sleeve.
20. Fastening cap.
21. Adjusting screw M10.
22. Pressing spring.
Turning the screw M10 clockwise increases the spring
tension and you can increase the brake torque.
3
WARNING
WARNING
Figure 4.
English